Simpson Strong-Tie Elevated Post Base
These post bases are popular in structural applications such as awning posts, pergola and veranda. Made from hot dip galvanised steel S235JR, they benefit from not needing to be matched.
Header member:
- Supporting member: solid wood, glued-laminated wood, concrete
- Supported member: solid wood, composite lumber, glued-laminated wood
Material:
- Steel S235JR according to NF EN 10025.
- Hotdip galvanized according to NF EN ISO 1461.
Dimensions:
- Thickness: 4mm
- Height: 130mm
- Top Plate: 100 x 100 mm
- Bottom Plate on ground: 130 x 130 mm
- Boulons: 8 Ø 12
- Characteristic Capacity Download: 76.1 kN
Applications:
- Awning posts
- Pergola
- Veranda
On post:
- Bolts.
- LAG lag screws 10 x 80 mm
On concrete:
- Mechanical anchor: WA M10-78/5 pin.
- Chemical anchor: AT-HP resin + LMAS M10-120/25 threaded rod
Installation
The bases are always installed in the same direction:
- Plate 130 x 130 mm on the ground.
- Plate 100 x 100 mm fastened on the post.
PPRC can be adjusted with a 30 mm wrench after both the plates are attached.
PPRIX requires the use of stainless steel fasteners.
ATTENTION: Post with maximum cross-section 200 x 200 mm.