Timloc Inter-Loc Horizontal Stopend RH
Best use for abutment of a flat roof with a cavity wall. At the abutment of a lean-to or mono pitch roof with a cavity wall. Over concrete ring beams. Over airbricks, cavity liners, ducts, meter boxes, etc. On external walls - not exceeding 102.5mm in thickness - built from standard brickwork, blockwork or stone. Clear cavity widths of between 50mm-125mm. Fits all clear cavity sizes up to 125mm.
- Suitable for brick, block and stone wall construction.
- 150mm highback upstand exceeds minimum requirements of NHBC.
- Angled section between cavity. Interlocking mechanism for jointing tray lengths to eliminate tray jointing.
- Built to brick bonding lengths for ease of use
- Angled section between cavity tray base and rear upstand automatically sheds water to the outer leaf
- Built independent to the inner leaf will enable inner and outer leafs to be built independently if required
- Available in two lengths: 4 brick for general use and 2 brick for reducing waste when making up a run of cavity tray to the required length
- The system is available upon request with pre-applied polystyrene strips. Polystyrene is much easier to rake out than mortar and offers a visual locator of the cavity tray so aiding the installation of post fitted lead work.
- Horizontal Inter-Loc Cavity Tray. The main cavity tray component. Sections join together by means of a lapped interlocking join, to form the main cavity tray run. Water is gathered by the cavity tray and is discharged from the wall through a series of weep holes - one weep hole per inter-loc tray is required.
- Corner Units. Allows the integrity of the main cavity tray run to be maintained when it is necessary to turn a corner on a building. Available in either external or internal format.
- Stopends. Fitted at the start and finish of the cavity tray run to seal off the open ends and prevent water running back into the cavity.
- Let Trade Counter Online take the load with our free Cavity tray specification and scheduling service (contact us for more information)