Spend £41.66 ex VAT more to qualify FREE Shipping
Simpson Strong-Tie Stainless Steel Type 2 Wire Wall Tie 75-100mm (1 Unit) (WTS2-225) Type 2 Wire Wall Tie 75-100mm ties are suitable for general-purpose applications, such as residential and...
Simpson Strong-Tie Stainless Steel Type 2 Wire Wall Tie 100-125mm (1 Unit) (WTS2-250) Type 2 Wire Wall Tie 100-125mm are suitable for general-purpose applications, such as residential and small...
Simpson Strong-Tie Stainless Steel Type 2 Wire Wall Tie 50-75mm (1 Unit) (WTS2-200) Type 2 Wire Wall Tie 50-75mm ties are suitable for general-purpose applications, such as residential and small...
Simpson Strong-Tie Stainless Steel Type 4 Wire Wall Tie 100-125mm (1 Unit) (WTS4-250) Type 4 Wire Wall Tie 100-125mm are suited for box-shaped homes up to 10 metres in height with leaves of...
SKU: WTS2-225
SKU: WTS2-250
SKU: WTS2-200
SKU: WTS4-250
Type 2 Wire Wall Tie 125-150mm are suitable for general-purpose applications, such as residential and small commercial structures up to 15 metres in height. Stainless Steel Type 2 Wire Wall Tie 125-150mm can also be installed in structures taller than 15 metres, but only if a calculation demonstrates that their performance is appropriate. Use on flat areas with wind speeds of up to 31 metres per second and altitudes of no more than 150 metres above sea level.
Recommended Positioning and Density for walls in which both leaves are 90mm or thicker, masonry ties need to be placed at not less than 2.5 per square metre (900mm horizontal x 450mm vertical centres). Stainless Steel Type 2 Wire Wall Tie 125-150mm should be evenly distributed throughout the wall area, with the exception of around openings and should be staggered where possible.
Where insulation board is installed within the cavity and restrained by ties with insulation retaining disces, it may be necessary to reduce the horizontal spacing of the ties to 600mm. At vertical edges of an opening, unreturned or unbonded edges, and vertical expansion joints - additional ties should be used at a rate of one per 300mm (height) and located not more than 225mm from the edge.
As stated within the Approved Document E 2003 - Resistance to the Passage of Sound - wall ties used in external and separating cavity walls have to have a minimum value of dynamic stiffness to reduce the transmission of airborne noise.
Technical Data Sheet
