Simpson Strong-Tie Stainless Steel Type 2 Wire Wall Tie 100-125mm (1 Unit) (WTS2-250)
Type 2 Wire Wall Tie 100-125mm are suitable for general-purpose applications, such as residential and small commercial structures up to 15 metres in height. Stainless Steel Type 2 Wire Wall Tie 100-125mm can also be installed in structures taller than 15 metres, but only if a calculation demonstrates that their performance is appropriate. Use on flat areas with wind speeds of up to 31 metres per second and altitudes of no more than 150 metres above sea level.
Recommended Positioning and Density for walls in which both leaves are 90mm or thicker, masonry ties need to be placed at not less than 2.5 per square metre (900mm horizontal x 450mm vertical centres). Stainless Steel Type 2 Wire Wall Tie 100-125mmshould be evenly distributed throughout the wall area, with the exception of around openings and should be staggered where possible.
Insulation Board
Where insulation board is installed within the cavity and restrained by ties with insulation retaining clips, it may be necessary to reduce the horizontal spacing of the ties to 600mm. At vertical edges of an opening, unreturned or unbonded edges, and vertical expansion joints - additional ties should be used at a rate of one per 300mm (height) and located not more than 225mm from the edge.
Sound Resistance
As stated within the Approved Document E 2003 - Resistance to the Passage of Sound - Stainless Steel Type 2 Wire Wall Tie 100-125mm used in external and separating cavity walls have to have a minimum value of dynamic stiffness to reduce the transmission of airborne noise.
Delivery rates are automatically calculated at the checkout and depend on destination, size, content and the value of the order.
Ireland Shipping: Estimated €13 exVAT
2 to 3 working days delivery time
Europe Shipping: Estimated €16 exVAT
4 to 5 working days delivery time
Worldwide Shipping: Calculated
5 to 7 working days delivery time depends on destination, size, content and the value of the order.